Black waterproofing membrane covering a foundation wall below red brick, open trench in front

Water-Powered Backup Sump Pump Installation in Macomb and Oakland County

A water-powered backup sump pump runs on city water pressure. It has no battery and uses no electricity, so it keeps pumping through a power outage for as long as the water main has pressure.

What will it cost?See approximate prices for your basement in about 30 seconds. Free, no phone number needed.

A water-powered backup sump pump runs on city water pressure. It has no battery and uses no electricity, so it keeps pumping through a power outage for as long as the water main has pressure. Some people call it a water backup sump pump. We install them for homes on municipal water across Macomb and Oakland County.

How a water-powered backup works

City water rushes through the unit and creates suction. The suction pulls water out of the sump pit and sends it out the discharge. For every gallon or so of city water it uses, it moves roughly two gallons out of the pit. The ratio varies by model and water pressure.

What it needs

  • Municipal water with good pressure. It does not work on a well, because the well pump is off in an outage too
  • A backflow preventer on the supply, to protect your drinking water. Most cities in our area require a permit for that
  • A discharge that cannot freeze shut, the same as the main pump’s line

What it does well, and where it falls short

  • No battery to check, replace or run flat
  • It runs as long as the water main has pressure, which in a long outage beats any battery
  • It uses water you pay for while it runs
  • Its capacity is lower than a battery unit’s, and in a very heavy flow it can struggle

Which homes it fits

It fits a home on city water whose owner wants outage protection measured in days, not hours. It can go in instead of a battery backup or alongside one. Waterford Township is one example: the township’s water comes from its own wells rather than from Detroit, and most houses on it have plenty of pressure to run a water-powered backup. Our Waterford Township sump pump page has more.

A home on a private well needs a battery backup instead. If the pit sees heavy flow, a second basin and pump may be the better plan. We tell you which one fits after we look.

What we install

We install Pro Series and Basement Watchdog (Glentronics) pumps and backups, with a check valve on each discharge. A water-powered backup ties into the home’s water supply through the backflow preventer, and we handle the basin, the pump, the discharge line and the backup pump.

The main pump still runs on electricity. We don’t do any electrical work, so an outlet near the pit is your licensed electrician’s job.

What a water-powered backup costs

A water-powered backup adds approximately $1,500 to a sump system. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

The backup carries its manufacturer’s warranty. It is not part of our 25-year transferable limited warranty, which covers our waterproofing work.

Keeping it ready

Test it twice a year: unplug the main pump, pour water into the pit and make sure the backup picks it up. We test backups on a yearly sump pump check-up too.

Water-powered backups near you

Want one priced for your house? Call (586) 345-7292 between 8 AM and 8 PM, any day of the week, or book a free estimate. Our main sump pump installation and replacement page covers pumps, pits and full systems. If the pump you have is acting up, see sump pump repair.

Water-powered backup sump pump questions

Does a water-powered backup sump pump work when the power is out?

Yes. It runs on city water pressure, with no battery and no electricity, for as long as the water main has pressure.

Can I use a water-powered backup on a well?

No. A well pump stops when the power does, so there is no pressure to run it. A home on a well needs a battery backup.

How much city water does a water-powered backup use?

For every gallon or so of city water it uses, it moves roughly two gallons out of the pit. The ratio varies by model and pressure, and it only uses water while it runs.

Does a water-powered backup need a permit?

It needs a backflow preventer on the water supply, and most cities in our area require a permit for that.

Is a water-powered backup as strong as a battery backup?

No. Its capacity is lower than a battery unit’s, and in a very heavy flow it can struggle. What it offers is run time: it does not run down in a long outage.

What does a water-powered backup sump pump cost?

It adds approximately $1,500 to a sump system. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

Frequently Asked Questions

Does a water-powered backup sump pump work when the power is out?

Yes. It runs on city water pressure, with no battery and no electricity, for as long as the water main has pressure.

Can I use a water-powered backup on a well?

No. A well pump stops when the power does, so there is no pressure to run it. A home on a well needs a battery backup.

How much city water does a water-powered backup use?

For every gallon or so of city water it uses, it moves roughly two gallons out of the pit. The ratio varies by model and pressure, and it only uses water while it runs.

Does a water-powered backup need a permit?

It needs a backflow preventer on the water supply, and most cities in our area require a permit for that.

Is a water-powered backup as strong as a battery backup?

No. Its capacity is lower than a battery unit's, and in a very heavy flow it can struggle. What it offers is run time: it does not run down in a long outage.

What does a water-powered backup sump pump cost?

It adds approximately $1,500 to a sump system. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

Have an invoice from us? Pay it online in under a minute.Card, Apple Pay, Google Pay or Cash App. Deposits, invoices and prepayments.

Pay Your Invoice Now