Black waterproofing membrane covering a foundation wall below red brick, open trench in front

Foundation Crack & Rod Hole Repair in Fraser, MI

We seal leaking foundation cracks and tie-rod holes in Fraser from inside the basement with epoxy, at the particular spots where poured walls let water in.

What will it cost?See approximate prices for your basement in about 30 seconds. Free, no phone number needed.

We seal leaking foundation cracks and tie-rod holes in Fraser from inside the basement with epoxy, at the particular spots where poured walls let water in. Approximate prices: $500 to $600 for a small crack, $1,500 for a full-height crack and $150 per rod hole, with a heavy discount on more than two. The estimate is free. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

Fraser is a small, square city of mostly mid-century homes on a mix of block and poured basements. Poured walls leak at shrinkage cracks and tie-rod holes, which epoxy injection seals from inside. Block walls need interior drainage, and we tell you which fix each wall needs.

Small, square and sitting on clay

Fraser covers about 4.2 square miles between 13 Mile, 15 Mile, Hayes and Kelly, with the Harrington Drain running north toward the Clinton River. The ground is heavy clay that holds water against a foundation for days after a storm. That steady push is what opens a hairline crack in a poured wall until it leaks.

Epoxy crack injection ports on a poured basement wall in Macomb Township, MI
Crack injection on one of our Macomb Township jobs.

Approximate prices in Fraser

JobApproximate price
Small crack (each)Approximately $500 to $600
Full-height vertical crack, never repairedApproximately $1,500 per crack
Full-height crack that was filled or patched beforeApproximately $2,000 per crack
Tie-rod (rod) holeApproximately $150 per hole
Horizontal crack, never patched beforeApproximately $1,500 per 7 ft of wall
Steel I-beam brace for a bowing wallApproximately $1,500 to $4,000 per brace

Contact us for accurate pricing. We have to inspect the job before we can give you a price.

Prices are by the job, never by the hour, confirmed at the free estimate.

Poured wall, block wall, or both

Fraser basements leak in one of two ways, depending on the wall. Poured concrete is solid, so leaks come in at particular spots: a shrinkage crack, a tie-rod hole or the place where a pipe passes through. Those are sealed from inside with epoxy, and the leak stops there. Concrete block leaks at the mortar joints and at the floor line, and its hollow cores fill with water, so injecting one spot does not fix it. In older block houses the original clay drain tile has usually silted up, and the fix is interior drain tile and a sump.

Why we use epoxy only

Epoxy fills the crack through the full thickness of the wall and cures hard, bonding both sides back together. Structural epoxy is about 10 times stronger than concrete in tensile and bond strength. We seal rod holes and finish the surface with an industrial two-part epoxy paste sold only by the manufacturer, not a hardware-store patch. More on rod hole repair.

How the repair goes

  1. We look at every wall and confirm what it is made of.
  2. We clean the crack or rod hole, set ports and inject epoxy from inside.
  3. We seal the surface with the two-part epoxy paste. No digging outside.
  4. Most crack and rod hole jobs are done in a few hours.

Bowing block walls

Mid-century block walls in wet ground can start to push in, and the sign is a horizontal or stair-step crack. Sealing that crack alone does not last. A moving wall gets steel I-beam braces, approximately $1,500 to $4,000 each, and a horizontal crack that was never patched runs approximately $1,500 per 7 feet of wall. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

More about basement waterproofing in Fraser, foundation crack repair and rod hole repair. Our 25-year transferable warranty covers our waterproofing work. Nearby: crack repair in Clinton Township and Warren. Book a free estimate.

Crack and rod hole repairs we have done

More services in Fraser

See everything we do on our Fraser basement waterproofing page.

Questions about crack repair in Fraser

How much does foundation crack repair cost in Fraser?

Approximately $500 to $600 for a small crack and approximately $1,500 for a full-height crack, or $2,000 if it was filled or patched before. Rod holes run approximately $150 each, and more than two get a heavy discount. Contact us for accurate pricing. We have to inspect the job before we can give you a price. The estimate is free.

Why does our crack leak days after it stops raining?

Clay holds water against the wall long after the rain ends, so the pressure stays on the crack. Epoxy injection seals it through the full thickness of the wall, so the water has nowhere to come through.

Water is coming in where a pipe goes through my Fraser basement wall. Can you seal that?

Yes. In a poured wall, leaks come in at particular spots: a shrinkage crack, a tie-rod hole or the place where a pipe passes through. Each is sealed from inside.

Is crack injection covered by your warranty?

Yes. Waterproofing work, including crack injection, carries our 25-year transferable limited warranty on our workmanship. Wall bracing is not covered by it.

Watch recent crack injection jobs

Real jobs filmed by Imad “Matt” Mansour and the crew – no stock footage. Tap a video to play it with sound.

Foundation Crack Repair in Rochester Hills, MI – 38 Rod Holes Packed + Vertical Cracks Sealed

Active Foundation Crack Leak Stopped in 1 Hour – Rochester Hills, MI

Multiple Foundation Cracks Repaired in Washington Township, MI – Leaking & Preventive Injection

Vertical Foundation Crack + 6 Rod Holes Sealed – Rochester Hills, MI

See more job videos on our TikTok · Browse our project gallery

Have an invoice from us? Pay it online in under a minute.Card, Apple Pay, Google Pay or Cash App. Deposits, invoices and prepayments.

Pay Your Invoice Now