Short answer: A new sump pump system in Washington Township costs approximately $2,500 to $3,000, a pump replacement in a sound basin approximately $600, and a battery or water-powered backup approximately $1,500 extra. If your pump isn’t working right, we repair it or tell you honestly when it’s time to replace it. Contact us for accurate pricing. We have to inspect the job before we can give you a price.
Washington Township is about 15 minutes from our Shelby Township base, so a pump that quits is a short drive for us.
Sump pump repair
Many calls start with a pump that’s acting up, not one that’s dead. These are the problems we fix:
- Pump runs but doesn’t empty the pit: often a stuck or failed check valve, or a clogged intake.
- Pump won’t shut off: a float that’s stuck, tangled on the cord or rubbing the side of the pit.
- Pump cycles on and off every few seconds: a bad check valve letting water fall back, or a pit that’s too small.
- Loud grinding or rattling: worn bearings or debris in the impeller.
- Pump trips the breaker: a failing motor. We replace the pump; your electrician handles anything on the circuit, since we don’t do electrical work.
Our sump pump repair page walks through each of these and what a repair visit looks like.
If the pump is old and failing, a replacement in the same basin is approximately $600, often less than chasing repairs. Contact us for accurate pricing. We have to inspect the job before we can give you a price.
Common sump problems in Washington Township homes
- Heavy clay: clay holds water against the foundation, so pumps run hard every spring and wear out early.
- Long discharge lines on big lots: they can freeze in winter, and a line that ends near the house sends the water right back.
- Power outages: a storm that knocks the power out is exactly when a basement floods without a backup.
- Old open pits: they let silt in and moisture into the basement.
What we install
- Full sump systems: a sealed basin set into the floor, a new pump, check valve and discharge piping.
- Pump replacements in an existing, sound basin.
- Battery backup or water-powered backup pumps. Water-powered backups need city water pressure, so homes on a well get a battery backup.
- Discharge lines buried below the frost and run away from the house to a dry well or an approved outlet, never into a septic system.
We install Pro Series and Basement Watchdog pumps, which carry the manufacturer’s warranty.
More detail on the parts of the system: battery backup sump pumps, water-powered backup sump pumps and sump pump discharge lines.
What sump pump work costs in Washington Township
| Job | Approximate price |
|---|---|
| Full sump system | Approximately $2,500 to $3,000 |
| Pump replacement in an existing basin | Approximately $600 |
| Battery backup or water-powered backup | Approximately $1,500 extra each |
| Discharge line | Approximately $1,500 to $6,500, depending on length |
| Service visit for a repair | $200 minimum |
Contact us for accurate pricing. We have to inspect the job before we can give you a price.
A yearly sump check-up catches a worn pump or a stuck float before it fails. See our sump check-up.
More services in Washington Township
- Sewer camera inspection in Washington Township
- Hydro jetting in Washington Township
- French drain and yard drainage in Washington Township
- Excavation contractor in Washington Township
- Egress window installation in Washington Township
- Backwater valve installation in Washington Township
- Exterior basement waterproofing in Washington Township
- Interior basement waterproofing in Washington Township
- Foundation repair in Washington Township
- Foundation crack and rod hole repair in Washington Township
- Water line replacement in Washington Township
- Sewer line repair in Washington Township
See everything we do on our Washington Township basement waterproofing page.
Questions about sump pumps in Washington Township
My sump pump is running but the water isn’t going down. What’s wrong?
Usually a failed check valve, a clogged intake or a frozen or blocked discharge line. We find which one and fix it.
Should I repair or replace my sump pump?
If the pump is a few years old and the problem is a float, switch or valve, repair it. If the motor is failing or the pump is old, replacing it in the same basin is approximately $600 and usually the better buy. Contact us for accurate pricing. We have to inspect the job before we can give you a price.
We’re on a well. What backup can we get?
A battery backup. Water-powered backups run on city water pressure, so they don’t work on a well.
Do you handle emergencies?
We answer calls 8 AM to 8 PM, 7 days a week, with fast emergency response.
Call 586-345-7292, 8 AM to 8 PM, 7 days a week, with fast emergency response, or book a free estimate. More on our sump pumps page, our Washington Township interior waterproofing page and our Washington Township page.
Watch recent sump pump jobs
Real jobs filmed by Imad “Matt” Mansour and the crew – no stock footage. Tap a video to play it with sound.
Interior Waterproofing + Sump Pump Repair in Rochester Hills, MI – 30 ft Drain System
Old-School Sump Pump With No Basin Replaced With a Modern Sump System – Troy, MI
Sump Pump System Install – Dryden, MI
Secondary Sump Basin & Pump Added for Heavy Groundwater – Dual Sump System Install
See more job videos on our TikTok · Browse our project gallery
