“Can you just seal the walls?” is one of the first things homeowners ask us. Sometimes the answer is yes. A lot of the time, sealing alone won’t hold, and we’d rather tell you that up front than sell you a coating that peels off by next spring.
We’re Mansour’s Innovations, a waterproofing, excavation and plumbing contractor in Shelby Township. We’ve sealed, injected and drained basement walls across Macomb, Oakland and Wayne counties since 2014.
What a sealer can do, and what it can’t
A good masonry sealer or waterproof coating handles dampness. It slows down moisture that wicks through concrete, cuts down on that white powdery residue, and keeps a wall that’s damp, but not leaking, from making the basement musty.
What it can’t do is hold back water under pressure. When the clay outside is saturated, the water pushes on the wall from behind. A coating on the inside face is fighting that push from the wrong side, and it blisters, flakes or lets go. If you see water running down a wall or puddling at the bottom after a storm, a sealer isn’t the fix.
Block walls versus poured walls
Block walls, common in postwar ranches across south Macomb, south Oakland and Wayne County, are hollow. Water fills the cores and seeps out through the mortar joints, mostly near the bottom of the wall. Painting the face doesn’t empty the cores. On a block wall that’s actually leaking, the water needs a way out: weep holes drilled into the bottom row and an interior drain tile system to carry it to a sump.
Poured concrete walls, common in houses from the 1960s on, in places like Troy, Rochester Hills and much of northern Macomb, are solid. When they leak, it’s almost always at a specific spot: a crack, a tie-rod hole left from the forms, or a pipe that comes through the wall. On a poured wall, seal the spot, not the wall. Crack injection fills the crack or tie-rod hole all the way through the wall instead of just covering the inside face.
Sealing from the outside
The only place a coating can really stop water is the outside of the wall, where the water hits it first. That means digging down to the footing, cleaning the wall, and putting a membrane on it, with drainage at the bottom. That’s exterior waterproofing, and it’s the most complete fix for a wall that leaks along its whole length. Parging, the cement coat on the outside of the wall above the dirt, helps keep the top of the wall tight, but it’s not waterproofing by itself.
How to tell if sealing is enough
- The wall feels cool and damp, or has white powder, but you’ve never seen water run: sealing may be all it needs.
- Water shows up at one crack or one tie-rod hole: inject that spot.
- Water runs out along the bottom of a block wall: it needs drainage, not paint.
- Water comes through a wall in many places: look at exterior waterproofing.
We’ll check the wall with a moisture meter and show you what we find before we recommend anything.
Where we work
We have pages that go deeper into the walls we see in each county: Macomb, Oakland and Wayne County, including the older brick and stone foundations in the Grosse Pointes.
Questions we get about sealing walls
Will Drylok or a similar paint stop my leak?
It can help with dampness. It won’t stop water that’s pushing through a crack or out of the bottom of a block wall.
Is waterproofing covered by a warranty?
Our waterproofing work carries a 25-year transferable limited warranty. A sealer applied alone to manage dampness isn’t a waterproofing system, and we’ll be clear about that before any work starts.
What does it cost?
Anywhere from a single crack to a full exterior job, so it depends on what the wall needs. We give you an exact price after a free on-site look.
Call (586) 345-7292 for a free estimate. We book from 8 a.m. to 8 p.m. every day and answer emergency calls 24/7.
