Black waterproofing membrane covering a foundation wall below red brick, open trench in front

Steel I-Beam Wall Braces for Bowing Basement Walls in Macomb and Oakland County

Steel I-beam braces hold a basement wall that is bowing, leaning or cracked sideways, so it stops coming in.

What will it cost?See approximate prices for your basement in about 30 seconds. Free, no phone number needed.

Steel I-beam braces hold a basement wall that is bowing, leaning or cracked sideways, so it stops coming in. We install them in homes across Macomb and Oakland County, fill the crack as part of the same job, and can pull the building permit for you.

When a wall needs steel braces

Most basement problems are about water. A bowing wall is about the wall itself. Wet clay swells and freezes against the outside of the foundation and pushes harder than the wall was built to take. Sealing the crack does not stop that push. The wall has to be held.

  • A long horizontal crack, often partway up a block wall
  • A wall that bulges in at the middle or leans in at the top
  • Stair-step cracks along the mortar joints, where the blocks above no longer line up with the blocks below
  • A gap opening where the wood framing sits on top of the foundation

Steel braces are for a wall that is bowing or leaning more than a little. A wall that has only started to move may only need carbon fiber reinforcement. We measure the wall at the free estimate and tell you which one fits.

How steel I-beam braces work

Each brace is a steel I-beam set upright against the inside of the wall. The bottom is anchored at the footing below the basement floor, and the top is fastened to the floor joists above. The beams go in about every four to six feet along the wall. Together they hold the wall where it is, so it does not keep coming in and the crack can be repaired.

Some brace systems can be adjusted over time. A badly bowed wall is a different case. It may need to be dug out on the outside first, to take the soil pressure off, and a wall that has moved too far to brace may need rebuilding. We don’t do wall rebuilds, piering or underpinning, and we tell you at the estimate if your wall is past bracing.

Block walls and poured walls

Block walls bow more often than poured walls, because the mortar joints are the weak spot. The wall bends at a joint and leans in above it. Plenty of older houses here sit on block, from the postwar neighborhoods of Warren, Roseville and Eastpointe to Sterling Heights, the south ends of Clinton and Shelby townships and Waterford’s lakefront ranches. A long horizontal crack in a block wall, sometimes 20 feet or more, usually needs the whole crack filled plus braces.

What the job looks like

  • Measure: we measure how far the wall has moved and check which way the cracks run, to make sure bracing is the right fix
  • Permit: bracing a basement wall is structural work, and under Michigan’s residential code it generally needs a building permit. Your city or township building department decides. We can pull the permit for you
  • Getting the wall ready: anything stored along the wall gets moved. In a finished basement, the drywall comes off where the braces go
  • The repair: we fill the crack and set the braces
  • Inspection and cleanup: your city inspects the work if the permit calls for it. We clean up and show you the finished repair

The beams stand a few inches out from the wall, so plan around them if you finish the basement later.

Keep the water off the wall

Braces hold the wall. They do not keep the clay behind it dry. If roof water and the yard keep soaking the soil against that wall, the braces are holding back a wall that keeps getting pushed. At every estimate we look at the gutters, downspouts and grading along with the wall. When the wall also leaks, exterior waterproofing can be done in the same job, and exterior drainage carries roof and yard water away.

What steel I-beam braces cost

Steel I-beam wall braces are approximately $1,500 to $4,000 per brace. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

A wall that needs several braces gets a heavy discount. We price by the job, never by the hour, and the estimate is free. Every price for cracks, rod holes, carbon fiber and braces is on our foundation repair cost in Michigan page.

Warranty

Our 25-year transferable limited warranty covers waterproofing work only. Wall braces are not part of it. They carry only the warranty written on your contract or invoice, plus any manufacturer’s warranty.

More on bowing walls

Wall bracing near you

To have a wall measured, call (586) 345-7292, 8 AM to 8 PM, 7 days a week, or book a free estimate.

Steel I-beam wall brace questions

How far apart are steel I-beam braces set?

About every four to six feet along the wall. How many your wall needs depends on its length and how far it has moved, and we measure that at the free estimate.

Do steel braces straighten a bowed wall?

They hold the wall where it is, so it does not keep coming in. Some systems can be adjusted over time. A badly bowed wall usually is not pushed fully straight.

Can you just seal a horizontal crack?

Sealing can stop the water for a while, but it does not stop a wall that is being pushed, and the crack opens again. A long horizontal crack in a block wall usually needs the whole crack filled plus braces.

Do I need a permit to brace a basement wall?

Usually, yes. It is structural work, and under Michigan’s residential code it generally needs a building permit. Your building department decides and sets the fees and inspections. We can pull the permit for you.

Will the braces be in the way if I finish the basement?

The beams stand a few inches out from the wall, so the finishing has to be planned around them. In a basement that is already finished, the drywall comes off where the braces go.

What do steel I-beam wall braces cost?

They are approximately $1,500 to $4,000 per brace, with a heavy discount when a wall needs several. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

Frequently Asked Questions

How far apart are steel I-beam braces set?

About every four to six feet along the wall. How many your wall needs depends on its length and how far it has moved, and we measure that at the free estimate.

Do steel braces straighten a bowed wall?

They hold the wall where it is, so it does not keep coming in. Some systems can be adjusted over time. A badly bowed wall usually is not pushed fully straight.

Can you just seal a horizontal crack?

Sealing can stop the water for a while, but it does not stop a wall that is being pushed, and the crack opens again. A long horizontal crack in a block wall usually needs the whole crack filled plus braces.

Do I need a permit to brace a basement wall?

Usually, yes. It is structural work, and under Michigan's residential code it generally needs a building permit. Your building department decides and sets the fees and inspections. We can pull the permit for you.

Will the braces be in the way if I finish the basement?

The beams stand a few inches out from the wall, so the finishing has to be planned around them. In a basement that is already finished, the drywall comes off where the braces go.

What do steel I-beam wall braces cost?

They are approximately $1,500 to $4,000 per brace, with a heavy discount when a wall needs several. Contact us for accurate pricing. We have to inspect the job before we can give you a price.

Have an invoice from us? Pay it online in under a minute.Card, Apple Pay, Google Pay or Cash App. Deposits, invoices and prepayments.

Pay Your Invoice Now