Black waterproofing membrane covering a foundation wall below red brick, open trench in front

Basement Crack Repair in Troy, MI

Epoxy injection for leaking cracks and tie-rod holes in Troy’s 1960s and 70s poured walls, with approximate prices and straight answers about what a crack means.

What will it cost?See approximate prices for your basement in about 30 seconds. Free, no phone number needed.

We repair leaking basement wall cracks and tie-rod holes in Troy from inside the basement, injecting epoxy through the full thickness of a poured concrete wall so water has no open path left. Approximate prices are approximately $500 to $600 for a small crack, approximately $1,500 for a full-height crack ($2,000 if someone already filled or patched it), and approximately $150 per tie-rod hole. The estimate is free, and we come down from Shelby Township.

Troy went from about 19,000 people in 1960 to over 67,000 in 1980, and most of its basements were poured or laid in that twenty-year rush. They fail mostly at tie-rod holes and shrinkage cracks, and they sit in clay that never really drains.

What a crack means in a Troy basement

By now a lot of Troy basements are past the 40-year mark. The backfill has settled, the clay outside stays wet, and the water it holds finds the weakest spot in the wall, which is almost always a crack or a rod hole.

A poured Troy wall with a leaking vertical crack is a water problem, not a structural one, and epoxy injection from inside fixes it for good. A block wall from the same years leaks differently, mostly where the wall meets the floor.

Approximate prices for basement crack repair in Troy

JobApproximate price
Small crack (each)Approximately $500 to $600
Full-height vertical crack, never repairedApproximately $1,500 per crack
Full-height crack that was filled or patched beforeApproximately $2,000 per crack
Tie-rod (rod) holeApproximately $150 per hole
Horizontal crack, never patched beforeApproximately $1,500 per 7 ft of wall
Carbon fiber strips for a slight bowApproximately $1,500 to $2,500
Steel I-beam brace for a bowing wallApproximately $1,500 per brace

These are approximate prices by the job, never by the hour, and we confirm the number at the free estimate after we see the wall. More than two cracks or tie-rod holes on one job gets a discount.

Rod hole leaks in Troy

Troy’s poured walls have rows of tie-rod holes, and the snapped-off steel ends rust and let water in. We seal them from inside for approximately $150 each, with a discount when there are several, which there usually are.

How the repair goes

  • We look at the wall first and confirm whether it is poured concrete or block, because that decides the repair.
  • On a poured wall we clean the crack or rod hole, set injection ports and inject epoxy from inside until it fills the full thickness of the wall.
  • The epoxy cures hard and bonds both sides of the crack back together. There is no digging and no yard damage.
  • Most crack and rod hole jobs are done in a few hours, and you see the finished wall before we leave.

A leaking crack or a moving wall?

Most vertical cracks in poured walls are shrinkage cracks and are water problems only. A horizontal crack, a stair-step crack in block, or a wall that bows in is a structural problem, and that calls for foundation repair with steel I-beam braces or carbon fiber, not just a sealed crack. If water is coming in along the floor instead of through the wall, interior drain tile is the usual fix.

Recent jobs near Troy

More about basement waterproofing in Troy, foundation crack repair and rod hole repair. Nearby: basement crack repair in Rochester Hills, basement crack repair in Sterling Heights, Royal Oak. Book a free estimate.

Questions about crack repair in Troy

How much does it cost to fix a leaking basement crack in Troy?

Approximately $500 to $600 for a small crack and approximately $1,500 for a full-height crack, or $2,000 if it was filled or patched before. Tie-rod holes run approximately $150 each. More than two cracks or holes on one job gets a discount, and the estimate is free.

What do you fill basement wall cracks with?

Epoxy, on every crack we inject. It fills the crack through the full thickness of the wall and cures hard, bonding the two sides back together, so the clay outside has no open gap to push water through.

Our 1960s Troy ranch has a crack in a block wall. Can you inject it?

Not the way we inject poured concrete. Block is hollow, so injected material just fills the cores. On a block wall, water coming in at the floor is usually handled with interior drain tile, and a stair-step or horizontal crack in a wall that is moving gets braces.

What are the little round spots leaking on my poured wall?

Tie-rod holes. When a poured wall is formed, steel ties hold the forms together, and the snapped-off ends left in the wall can rust and leak. We seal each one from inside for approximately $150, less when there are several.

Is a crack in my basement wall a structural problem?

Usually not. Most vertical cracks in poured walls are shrinkage cracks. A horizontal crack, a crack wider than a pencil lead, or one where one side sticks out past the other is worth having us look at soon.

Watch recent crack injection jobs

Real jobs filmed by Imad “Matt” Mansour and the crew – no stock footage. Tap a video to play it with sound.

Foundation Crack Repair in Rochester Hills, MI – 38 Rod Holes Packed + Vertical Cracks Sealed

Active Foundation Crack Leak Stopped in 1 Hour – Rochester Hills, MI

Multiple Foundation Cracks Repaired in Washington Township, MI – Leaking & Preventive Injection

Vertical Foundation Crack + 6 Rod Holes Sealed – Rochester Hills, MI

See more job videos on our TikTok · Browse our project gallery

Frequently Asked Questions

How much does it cost to fix a leaking basement crack in Troy?

Approximately $500 to $600 for a small crack and approximately $1,500 for a full-height crack, or $2,000 if it was filled or patched before. Tie-rod holes run approximately $150 each. More than two cracks or holes on one job gets a discount, and the estimate is free.

What do you fill basement wall cracks with?

Epoxy, on every crack we inject. It fills the crack through the full thickness of the wall and cures hard, bonding the two sides back together, so the clay outside has no open gap to push water through.

Our 1960s Troy ranch has a crack in a block wall. Can you inject it?

Not the way we inject poured concrete. Block is hollow, so injected material just fills the cores. On a block wall, water coming in at the floor is usually handled with interior drain tile, and a stair-step or horizontal crack in a wall that is moving gets braces.

What are the little round spots leaking on my poured wall?

Tie-rod holes. When a poured wall is formed, steel ties hold the forms together, and the snapped-off ends left in the wall can rust and leak. We seal each one from inside for approximately $150, less when there are several.

Is a crack in my basement wall a structural problem?

Usually not. Most vertical cracks in poured walls are shrinkage cracks. A horizontal crack, a crack wider than a pencil lead, or one where one side sticks out past the other is worth having us look at soon.

Have an invoice from us? Pay it online in under a minute.Card, Apple Pay, Google Pay or Cash App. Deposits, invoices and prepayments.

Pay Your Invoice Now